+86-13696919243sink@symbolsink.com

Categories

Symbolsink Co Limited

Cel: +86-13696919243

E-mail: sink@symbolsink.com

Home > Exhibition > Content

how to install undermount stainless steel sink granite

Symbolsink Co Limited | Updated: Jun 14, 2017

believe that contact with Undermount Stainless steel sink friends will be the installation method of this kind of sinks very much like, and this is a popular in recent years a Flume installation method. The installation of the sink, not only has a better decorative effect, but also in the use of the effect and the use of life has a great advantage. Below, small make a detailed introduction to you Undermount Stainless steelsink installation method, interested friends come to know about it!

p201612150940303352468.jpg

Undermount Stainless steel sink installation-faucet installation

In the installation of the sink, the position of the table should be the size of the sink itself and the size of the area. So when choosing the sink, be sure to understand the size of the sink. Avoid rework. Then the first step in the kitchen sink basin installation is to install the faucet, the access of the water switch must be firmly, now the faucet has cold, hot points, this is because the faucet below the inlet pipe has two, one representative of cold water another represents hot water, the two pipes together to connect to the hose, and do not mistake the position. This is the faucet installation during the installation of the kitchen sink basin.

Undermount Stainless steel sink installation-inlet pipe

The inlet pipe, in fact, is the faucet drainage of the two pipes. First of all, to connect a water pipe to the drainage area, the installation must pay attention to the firmness and stability, but also to pay attention to these two water intake pipe and the location of cold, do not make mistakes. The installation method and way of two pipes are similar, but the water temperature is not the same. This is a very important part of the bottom basin installation of the kitchen sink, prepare the research plan ahead of time, and then operate the kitchen sink basin to install the process, it will not always error.

Undermount Stainless Steel Sink installation-supporting pendants

The so-called matching piece, in fact, is to avoid the gap is too small, and cause the water tank shaking instability and set the accessories. It is also the most crucial part of the bottom basin installation of the kitchen sink. After filling the sink with water, test the overflow hole, filtered blue drainage, and found that the water seepage around the sink, then rework immediately, check the installation around the sink. With the configuration of the hanging piece, the use of screws to tighten leveling, in the use of silica gel sealing around the sink, to ensure that the water tank around and mesa uniform. Although supporting the film is not enough to think, but after all, is also the kitchen sink basin installed in the process of a ring.