+86-13696919243sink@symbolsink.com

Categories

Symbolsink Co Limited

Cel: +86-13696919243

E-mail: sink@symbolsink.com

Home > Exhibition > Content

how to install over countertop kitchen sink

Symbolsink Co Limited | Updated: Jun 16, 2017

The installation of the sink we have already talked a lot, now how to install the sink silencer pad.

The sink is often noisy, at this time we will be upset, many consumers do not know how to solve, in fact, we can through the sink silencer pad to eliminate the noise, then how to install the sink muffler? Small make up to bring everybody to install sink silencer Mat.

p201704051452216196253.jpg

Sink silencer Cushion-sink Silencer Pad Installation

First of all, install the faucet inlet pipe, this step is very important, we will be installed in advance of the faucet on the end of the inlet pipe connected to the inlet switch, installation should pay attention to the cohesion of the firm, not firm words may lead to leakage and other serious problems may directly let the sink use, but also pay attention to a detail, is the location of hot and cold water pipe, do not confuse the left and right.

Then install overflow hole of the sewer pipe, overflow hole is to avoid the sink to overflow water protection hole, so in the installation of water pipes in overflow hole, to pay attention to the sealing with the groove body, to ensure that the overflow hole of the water pipe itself does not leak. Second, the installation of the filter basket of the sewer, filter basket under the water pipe in the installation, the main attention to the connection between the pipe and groove, not only to be firm, but also to seal.

Sink Silencer Pad-How to install sink silencer Mat

Installation of a whole drainage pipe, usually people will buy a two filter basket sink, but two of the distance between the water pipes, workers in the installation, will be based on the actual situation of the drainage pipe to cut, at this time to pay attention to the sealing between each interface, the common leakage problem occurs in these joints.

Finally, the installation of hanging piece reinforcement trough body, sink into the table, need to be in the trough body and the table to install the supporting hanging piece, the sink will be installed firmly, to avoid a small gap caused by the groove sway. Here we installed the kitchen sink to complete, we have to pay attention to check after the installation to see if there are any other problems to try again, found that there is no problem with the formal put into use.