Symbolsink Co Limited

Cel: +86-13696919243

E-mail: sink@symbolsink.com

Home > Exhibition > Content

how to install double bowl kitchen sink

Symbolsink Co Limited | Updated: May 19, 2017

Floating rust, mildew spot, is due to the installation of solder crumbs, cement, oil, and other residues in the surface of the sink, leakage, is the sink and Mesa Junction is not sealed or uneven size, the upper and lower water pipe is not sealed and caused by the hole, then the installation should pay attention to what? Let's take a look at the installation process of the double bowl kitchen sink.

Step one: Put the double bowl kitchen sink in place after the position is turned upside down, the sink and draw the outline along the edge of the sink.


Step two: Take the boiling water trough, and in the gutter contour line 1.0mm draw out the cutting line

Step three: Drill a 3/8 hole in the cutting line, insert the saw blade and cut along the cutting line, then grind the incision with sandpaper.

Step four: Fill in the outer side of the incision transparent silica gel, width of 3.2-6.4mm.


Step five: After the kitchen mixer is installed, the double bowl kitchen sink close to the forefront slowly put, covering the glue and slowly put flat.

Step Six: Check the position of the double bowl kitchen sink on the table again, apply the glass glue to the link bar, and finally clean the table.